Pixhawk Flight Control Board PPM Encoder V1.0 - 8 Channels

The PPM Encoder plugs into the PWM servo output ports of any R/C receiver and encodes them into a PPM pulse suitable for many autopilots (e.g., Pixhawk). No modifications to the R/C receiver are necessary.

The entire project is based on the ATMEL ATMEGA328p AVR processor, with all timing handled within interrupts to ensure optimal accuracy and stability. The design of the PPM Encoder is based on the Paparazzi PPM Encoder.

Important Note: The firmware comes pre-configured to read 8 Channels. If you wish to change the settings of the PPM encoder, such as inverting the PPM signal or modifying the fail-safe pre-defined values, you will need an AVR ISP programmer to reprogram it.

The jumper on the board is defaulted to no soldering. In this case, the board is powered by the flight controller (FC).

PPM Encoder V1.0 - 8 Channel Technical Specifications:

• Dimensions: 28 x 19 x 5 mm
• Net Weight: 8g

Package includes

1 Set PPM Encoder Module